Rhin-O-Tuff Onyx HD 7000

The Rhin-O-Tuff Onyx HD 7000 is a 14″ open-ended spiral, comb, wire and coil punching machine. With over 20 die options available, you can have your complete document punching station setup with just one machine. With the patented “quick-change” die system, you can swap dies in 30 seconds, and be punching for a completely different type of binding.

Designed to be user friendly, the HD7000 is easy to setup, adjust, and run. With a 3 Year Warranty, this machine is built to impress and last. Built to punch up to 40 sheets (80 pages) of 20lb paper (80 gsm) per punch, you can have your entire document in no time. The Onyx 7000 is ready to punch up to 14″ documents in a single punch, and has an open end to allow even larger document punching.

The Rhin-O-Tuff HD 7000 has been a popular machine with our customers, with everyone from small businesses to commercial printers using them on a daily basis. If you are looking for an all-in-one solution for your document punching, look no further than the HD 7000. To view more details or purchase your all in one HD7000, click here: Rhin-O-Tuff Onyx HD 7000

Skyline Book Binding

OnlineSkyline.com is the place to go for any binding, custom printing, laminating, shredding, and many other types of print type material and machines. Founded in 1998, we have been proud to serve and support thousands of individuals and companies over the years. Have something you need done? Give us a call at 1-866-455-9900 to speak with one of our friendly specialists.

You may also like...

2 Responses

  1. Mike says:

    We have an Rhin o Tuff HD7000 When we try to clamp down the die the handles do not lock into place. At first it was one side that was not locking the HD 7000 Dies into place then after a while it was happening on both sides. We added a little piece of metal to keep the die clamp tight. It is not the best way to fix the HD7000 Rhin o Tuff die clamp problem but it has been working. Is there a way to fix the die clamp for the HD7000 rhino tuff binding machine?

    • Hello Mike! The HD7000 die clamp problem is common and easy to fix. The die clamps on the HD 7000 Rhin-O-Tuff binding machine become loose over time due to vibration and use. The HD 7000 die clamps can be adjusted to work as good as new by following these instructions:

      Start by unclamping and sliding the die out of the machine. Using a 5/64” Allen wrench, loosen the 5/64” set screw on the die clamp. Adjust the clamping screw just enough to make it snug. Make sure to do this to both sides of the punch. After the adjustment has been made, slide the die back in to make sure that the die will clamp in the machine. Then slide the die back out and tighten the 5/64” set screws.

      Click here to view the picture: Rhin-O-Tuff Onyx HD 7000 Die Clamp Adjustment.

Leave a Reply

Your email address will not be published. Required fields are marked *